REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-57-
Press CR.
PROGRAM 55-0
LCR MODIFIED DIGITS-DELETE
ACTIONSTEP DISPLAY/PRINTOUT
1
>MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 55
P55
Enter Program Number 55
3 P55 1
5 To Exit Program/Store Data
A)
B)
C)
To store data, press CR.
Continue returning to step 3 until all data has been entered
for this program.
To exit this program, press # # CR.
Refer to the System Record Sheet and enter the modified
digits table number (1 ~ 6).
Example: Enter modified digits table number 1, enter 1.
4 P55 10 05 10Enter Code 0
The system will display any previously entered number of
digits to be deleted (01 ~ 10).
Refer to the System Record Sheet and change number if required.
Example: Change to 10, enter: 1 0.
Enter Modified Digits Table Number
P55 10 05 10
P55 ##
P
To Next Page
Loading...
