REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-58-
Press CR.
PROGRAM 55-1
LCR MODIFIED DIGITS-ADD
ACTIONSTEP DISPLAY/PRINTOUT
1
>MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 55
P55
Enter Program Number 55
3 P55 1
5 To Exit Program/Store Data
A)
B)
C)
To store data, press CR.
Continue returning to step 3 until all data has been entered
for this program.
To exit this program, press # # CR.
Refer to the System Record Sheet and enter the required
modified digits table number (1 ~ 6).
Example: Enter table number 1, enter 1.
4 P55 11
1 2 3 4 P3
Enter Code 1
The system will display any previously entered digits (up to 22).
Refer to the System Record Sheet and enter new numbers,
if required.
Example: Enter 1 2 3 4 P 3.
Enter Modified Digits Table Number
(up to 22 digits)
NOTE: Pause codes may also be entered. To enter pauses,
press "P" plus the pause number (1 ~ 8).
P55 11
1 2 3 4 P3
P55 ##
P
Special Code Input
Pause
Tone
Clear
=
=
=
P 1 ~ P 8.
T at beginning of digits to convert.
C as first digit, then CR.
To Next Page
Loading...
