REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-60-
PROGRAM 56
LCR STATION GROUP ASSIGNMENT
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE PROG
P
Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 P 56
P56
Enter Program Number 56
3 P56 01
Press CR.
5 To Exit Program/Store Data
A)
B)
C)
To store data, press CR.
Continue returning to step 3 until all data has been entered
for this program.
To exit this program, press # # CR.
Refer to the System Record Sheet and enter the
required port number, or
*
.
Example: Port 01, enter 0 1.
4 P56 01# 1 4
Press # Key
The system will display any previously entered group number (1 ~ 4).
Refer to the System Record Sheet and change as required.
Example: Change to 4, enter 4.
Enter Port Number
P56 01# 1 4
P56 ##
P
(if single port entry in step 3).
PROGRAM DATA DUMP
ACTIONSTEP DISPLAY/PRINTOUT
1 >MODE DUMP
D
Enter the Data Dump Mode
At the >MODE prompt, enter D U M P CR.
2 D PROGTo Output Program Data
3 To Stop Printout at Any Time D
Enter P R G CR
= Program number or A L L for all programs.
Enter DELETE CR at the same time.
4 To Exit the Dump Mode >MODE
Enter Q U I T CR.
To Next Page
Loading...
