T2150 Series
Installing the T2150CDT FL Inverter Board
To install the T2150CDT’s FL inverter board, follow the steps below and refer to figure 4-29.
1. Connect the FL inverter cable to CN1 and the FL cable to CN2 on the FL
inverter board (figure 4-29).
2. Seat the FL inverter board and route the cables so they will not be pinched by
the display cover or other component.
3. Secure the FL inverter board with two M2.5x6 screws (figure 4-29).
4. Install the display mask, optional memory module, optional PCMCIA card, and
battery pack as described in sections 4.11, 4.4 back through 4.2.
To Next Page
Loading...
