Toshiba TOSVERT BCN001Z - Analog Value Object Instance

E6581440
- 14 -
4.2.6. Analog Value Object Instance
The analog value objects allow to monitor drive status such as output frequency, current
and voltage. Additionally, drive speed reference can be set as Analog Value #16.
Binary
Value ID
Object Name Description UNIT Access
#0 OUTPUT SPEED Output speed[min
-1
](Calculate from fd00) min
-1
R
#1 OUTPUT FREQ Output frequency[Hz](fd00) Hz R
#2 DC BUS VOLT DC bus voltage (Calculate from fe04) V R
#3 OUTPUT VOLT Motor voltage(Calculate from fe05) V R
#4 CURRENT Motor current(Calculate from fe03) A R
#5 TORQUE Motor Torque(fe18) % R
#6 POWER
Motor Power(Calculate from fe30)
100%=√3×VSD rate voltage ×Motor rate current
% R
#7 DRIVE TEMP
Drive Thermal State(fd24)
OL1 will be caused, if this value reaches 100%,
% R
#8 KWH (R) Energy counter(Calculate from fd76,fd77) KWH R
#10 PRC PID FBCK PID regulator feedback (fe22 / vl*100.00) % R
#14 RUN TIME Cumulate operation time (fe14) hour R
#16 INPUT REF 1 Speed reference (fa07/vl*100) % C
#18 LAST FLT Current fault code(fc90) - R
#19 PREV FLT 1 Past fault code(most recent fault)(fe10) - R
#20 PREV FLT 2 Past fault code(fault before most recent)(fe11) - R
#23 ACCEL1 TIME * Acceleration time(acc) SEC W
#24 DECEL1 TIME * Deceleration time(dec) SEC W
#25 MBOX PARAM Parameter number - W
#26 MBOX DATA Parameter value - W
* Avoid frequently writing to these objects, because the Life of EEPROM is approximately 100,000 times.
R=Read-only, W=Writable, C=Commandable.