Toshiba RemotEye 4 - User Manual

Toshiba RemotEye 4

262 pages

To Next Page

To Next Page

Loading...

RemotEye



4

User Manual

Document Number: 90988-007

September 2018

Table of Contents

About this Manual2
Contacting Toshiba's Customer Support Center3
Important Notice3
Important Safety Instructions3
Table of Contents5
List of Figures9
List of Tables11
1 General Safety Instructions13
- Safety Alert Symbols13
- Special Symbols13
- Electrical Hazard Symbol13
- Explosion Hazard Symbol14
  - Equipment Warning Labels14
  - Installation Precautions14
2 Introduction15
- Purpose & Manual Overview15
- Applicable Specifications15
- Ups Compatibility16
- Package Contents16
- Remoteye 4 Layout and Led Indicators17
- Figure 2-1 Remoteye 4 Faceplate Layout17
- Table 2-1 Remoteye 4 Connections17
- Hard Reset Button18
  - Figure 2-2 Remoteye 4 Hard Reset Button Access18
  - Figure 2-3 Remoteye LED Locations19
  - Table 2-2 Remoteye 4 LED Indications19
  - Features20
- HTTP Web Access20
- SNMP Access20
- Figure 2-4 HTTP Web Access Dashboard Example20
- Bacnet and Modbus Access21
- Additional Features21
- Figure 2-5 *** SNMP Access to Remoteye 421
- Remoteye 4 Support Software Programs22
- Optional - Environmental Monitoring Device (EMD)22
- Optional - Remoteye Sensor Pack for EMD23
- Optional - Remotradar Software23
- Figure 2-6 EMD Module23
- Figure 2-7 EMD Sensor Pack23
3 Setup24
- Checklist24
- Figure 2-8: Remotradar Example24
- Table 3-1 Set-Up Checklist24
- Install Remoteye 4 in Ups25
- Figure 3-1 Remoteye 4 MAC Address Location25
- Figure 3-2 Remoteye 4 Location in 1600XP25
- Figure 3-3 Remoteye 4 in 4300 and 4400 UPS26
- Figure 3-4 Remoteye 4 in G9000/G2020 UPS26
- Figure 3-5 Remoteye 4 in G9000 1000Kva27
4 Remoteye 4 Network Connection Setup31
- Ip Address Setup with Dhcp31
- Table 4-1 Monitoring Protocol and Port Connector31
- Ip Address Setup with Custom Network Settings32
- Install USB Driver (Windows 8.1)32
- Figure 4-1 Remoteye 4 Network Connection Example32
- Install USB Driver (Windows 7)33
- Establishing Comminication33
- Figure 4-2 PC to Remoteye 4 USB-Mini-USB Cable Adapter33
- Set the IP Address34
- Figure 4-3 Tera Term Opening Screen34
- Figure 4-4 Serial Port Setup34
- Figure 4-5 Remoteye 4 Configuration Utility Main Menu35
5 System Configuration Via Web Interface36
- Software Setup36
- First Time Setup36
- Customizing the Dashboard Layout42
- UPS MONITORING Drop-Down Menu45
- Figure 5-14 Drop-Down Menus45
- Figure 5-15 SETTINGS Web Page45
- UPS MANAGEMENT Drop-Down Menu46
- SETTTINGS Drop-Down Menu46
- EMD Drop-Down Menu46
- Username} Drop-Down Menu46
6 Protocol Setup47
- Snmp Setup47
- Figure 6-1 SNMP Settings Panel47
- Toshiba MIB Files48
- NMS (Manager) Settings48
  - Modbus Tcp/Ip or Bacnet Ip Setup48
- Configure for Modbus TCP/IP48
- Configure for Bacnet IP49
  - Figure 6-2 Modbus TCP/IP and Bacnet IP Configuration Panels49
  - Modbus Rtu or Bacnet Ms/Tp Setup50
- Configure for Modbus RTU50
- Figure 6-3 Remoteye 4 RS-485 Data and GND Cabling50
- Figure 6-4 Interface Settings for Modbus RTU50
- Figure 6-5 Modbus Settings for Modbus RTU51
- Figure 6-6 Modbus Read/Write Definitions51
- Configure for Bacnet MS/TP52
- Figure 6-7 Example - Modbus Poll for 1600XP52
- Figure 6-8 Remoteye 4 RS-485 Data and GND Cabling53
- Figure 6-9 Interface Settings for Bacnet MS/TP53
- Figure 6-10 Bacnet Settings for Bacnet MS/TP54
7 Optional Features Setup55
- Radius Configuration55
- Email Notification55
- Table 7-1 Daily/Event Status Logs56
- Reminders57
- Wireless System Settings57
- Remoteye 4 System Settings57
- Figure 7-1 Wireless System Settings View57
- Emd (Environmental Monitoring Device)58
- EMD Installation59
- EMD Parameters59
- Table 7-2 EMD Layout and Indicators59
- EMD Configuration60
8 Mobile-Friendly Web Interface61
- Display and Navigation61
- Figure 8-1 Mobile Webpage by Product Line61
- Alert Center62
- Protected Clients62
- Figure 8-2 Input Parameters Mobile Webpage - by Product Line62
- Figure 8-3 Example of Alert Center and Protected Clients62
9 Remoteye 4 Console Menu Navigation63
- Table 9-1 Console Menu Tree63
10 History Data & Logs81
- Ups History Summary Summary Page81
- Table 10-1 History Log Availability81
- Table 10-2 UPS History Summary Page Availability81
- General Records Page82
- Extended General Records Page82
- Test Records (T1000 & 1600Xp/Xpi Only)83
- Backup Records Page83
- Fault Records Page84
- Operation Mode Records Page86
- Warning Records Page87
- System Settings Change Records Page (T1000 & 1600Xp/Xpi Only)89
11 Remoteye Application Programs91
- Remoteye Client Shutdown Software for Esxi 5/5.1/5.5/6.091
- Software Needed91
- Figure 11-1 Network with Remoteye and Esxi Servers91
- Setup Procedure for Remoteye Esxi Client Shutdown Daemon92
- Figure 11-2 Text Turns RED in Super User Mode92
- Figure 11-3 Add Server to Vma92
- Figure 11-4 Esxi Added to VMA92
- Figure 11-5 Winscp Login Screen93
- Figure 11-6 Winscp VI-Admin Screen94
- Figure 11-7 Install Screen Shot95
- Figure 11-8 Protected Client Table in Remoteye95
- Figure 11-9 Vsphere Management Asistant Screen Shot96
- Figure 11-10 VM Remote Shutdown Test97
- Toshiba UPS Shutdown Events Setup98
12 Specifications106
- System Specifications106
- Table 12-1 Remoteye 4 System Specifications106
- Led Indicators Key107
- Table 12-2 Remoteye 4 LED Indications107
- Firmware Specifications108
- Pcb Gold Finger (Gf1)108
- Network Connector (J2)108
- Rs-232/Emd Cabling Key (J3)108
- Figure 12-1 PCB Top View/Goldfinger108
- Table 12-3 Firmware Specifications108
- Table 12-4 Pin-Outs for Network RJ-45108
- Table 12-5 Pin-Outs for RS-232/EDM RJ-45108
- Rs-485 Cabling Key109
- Figure 12-2 Remoteye 4 Faceplate109
- Table 12-6 Pin-Outs for RS-485 (Phoenix) Connector109
Appendix A - Modbus Registers for All Ups110
- Modbus (3X) Input Registers for G9000/G2020 Series Ups: Monitoring110
- Modbus (3X) Input Registers for 4300, 4400, and 5000 Series Ups: Monitoring121
- Modbus (3X) Input Registers for Single Phase Ups: Monitoring131
- Modbus (1X) Input Registers for Three Phase Ups: Alarms and Status143
- Modbus (1X) Input Registers for Single Phase Ups: Alarms and Status152
Appendix B - Bacnet Point Mapping for 1600Xp/Xpi163
- Bacnet Analog Input Point Mapping for 1600Xp/Xpi163
- Bacnet Binary Input Point Mapping for 1600Xp/Xpi167
Appendix C - Bacnet Point Mapping for 4300171
- Bacnet Analog Input Point Mapping for 4300171
- Bacnet Binary Input Point Mapping for 4300174
Appendix D - Bacnet Point Mapping for 4400178
- Bacnet Analog Input Point Mapping for 4400178
- Bacnet Binary Input Point Mapping for 4400182
Appendix E - Bacnet Point Mapping for G9000/G2020187
- Bacnet Analog Input Point Mapping for G9000/G2020187
- Bacnet Binary Input Point Mapping for G9000/G2020190
Appendix F- Bacnet Point Mapping for 5000 Nema 3R192
- Bacnet Analog Input Point Mapping for 5000 Nema 3R192
- Bacnet Binary Input Point Mapping for 5000 Nema 3R196
Appendix G- Bacnet Point Mapping for T1000200
- Bacnet Analog Input Point Mapping for T1000200
- Bacnet Binary Input Point Mapping for T1000203
Appendix H - - Bacnet Point Mapping for T1000 (1-3Kva)206
- Bacnet Analog Input Point Mapping for T1000 (1-3Kva)206
- Bacnet Binary Input Point Mapping for T1000 (1-3Kva)208
Appendix I - - Bacnet Point Mapping for 5000 (3P1)210
- Bacnet Analog Input Point Mapping for 5000 (3P1)210
- Bacnet Binary Input Point Mapping for 5000 (3P1)213
Appendix J - - Bacnet Point Mapping for G9000/G2020 V2216
- Bacnet Analog Input Point Mapping for G9000/G2020 V2216
- Bacnet Binary Input Point Mapping for G9000/G2020 V2219
Appendix K - Snmp Mib Oid's for 1600Xp/Xpi222
Appendix L - Snmp Mib Oid's for 4300228
Appendix M - Snmp Mib Oid's for 4400233
Appendix N - Snmp Mib Oid's for G9000/G2020238
Appendix O - Snmp Mib Oid's for 5000 Nema 3R241
Appendix P - Snmp Mib Oid's for T1000246
Appendix Q - Snmp Mib Oid's for T1000 (1-3 Kva)250
Appendix R - Snmp Mib Oid's for 5000 (3P1)252
Appendix S - Snmp Mib Oid's for G9000/G2020 V2256
Appendix T - Additional Rs-485 Connection Information260

Other manuals for Toshiba RemotEye 4

Procedure For Installing8 pages

Need help?

Do you have a question about the Toshiba RemotEye 4 and is the answer not in the manual?

Toshiba RemotEye 4 Specifications

General

Category	Network Card
Connectivity Technology	Wireless
Data Link Protocol	IEEE 802.11b, IEEE 802.11g
Wireless Standard	802.11b/g
Frequency Band	2.4 GHz
Maximum Data Rate	54 Mbps
Security	WPA, WEP

Summary

General Safety Instructions

Installation Precautions

Guidelines for safe and optimal unit installation.

Introduction

Hard Reset Button Access

Instructions for performing a hard reset to restore default parameters.

RemotEye 4 Network Connection Setup

IP Address Setup with DHCP

Steps to automatically obtain an IP address using DHCP for network connection.

IP Address Setup with Custom Network Settings

Manual configuration of IP settings using a PC and terminal emulation software.

System Configuration via Web Interface

First Time Setup

Initial setup process to configure username, password, and system details.

Protocol Setup

SNMP Setup

Modbus TCP;IP or BACnet IP Setup

Modbus RTU or BACnet MS;TP Setup

Optional Features Setup

RemotEye 4 Console Menu Navigation

RemotEye 4 Card Settings

Reset Configuration to Default

Resets all RemotEye 4 parameters to factory initial settings.

History Data & Logs

RemotEye Application Programs

Tupgrade - Firmware Tool

Manually upgrades RemotEye 4 firmware using an easy-to-use network utility.

Appendix A - Modbus Registers for All UPS

Appendix K - SNMP MIB OID’s for 1600 XP;XPI

Related product manuals

Preview: Toshiba H9 ASD

Toshiba TOSVERT BCN001Z