RemotEye 4 User Manual – 90988-007 105
Here is the way to manually Upgrade RemotEye 4 Firmware:
1) Web Interface: Go to Settings RemotEye 4 System Settings System/Network menu then Enable
Network Upgrade.
Note: To enable the Network Upgrade user has to change the security level to administrator by logging in
as Administrator.
2) Open the Tupgrade application software and click on the Discover icon. If no RemotEye 4 auto populates
press on the + icon and enter the IP, Username, and Password. If it still does not appear please check your
network security and your computer firewall.
3) Select the check box right next to the RemotEye 4 that will be updated.
4) Select the Edit button and enter the Username and Password.
5) Select the Open File button and select the firmware to be uploaded.
6) Select the Upgrade Firmware button to start the upgrade process.
Figure 11-18 Tupgrade Utility Opening Display
Table 11-1 Tupgrade Toolbar Functions
Manually set found device IP address, subnet mask and gateway
Get all device parameters. This generates a config file.
Use default browser to open homepage of selected device
Pop-up Add dialog to add one device
Delete one or more selected devices.
Pop-up Edit dialog to modify a device configuration.
Discover all RemotEye devices on the network.
Open the location (directory) of uploaded file.
Upgrade firmware after unit selected and file uploaded
Used in conjunction with the RemoteConfig Tool, the Tupgrade Tool can push/save a RemotEye 4 Config file to
one or more selected RemotEye 4’s simultaneously, making for a quick system setup.
To save RemotEye 4 Config file:
1) Discover or Manually add the RemotEye 4 to the list.
2) Select the check box of the RemotEye 4 to acquire config file.
To Next Page
Loading...
