STE 80722
– 10 –
If the external device is a server, use the client setting for the controller, and if the
external device is a client, use the server setting for the controller.
= (Robot controller IP address)
[E02] Robot controller name
(Planned for use in function expansion)
[E02] Robot controller name
= “NO1-TS3K”
This parameter specifies the name of the robot controller.
This is planned for use when the Ethernet function is expanded.
[E03] Subnet mask
[E03] Subnet mask
= 255.255.255.0
This parameter specifies the subnet mask of the connected network.
When connecting to a LAN, set the subnet mask by following the instructions of the
user's LAN system administrator.
= (Subnet mask)
To Next Page
Loading...
Need help?
General
