Toshiba Vm Series - Network

Unified Controller Vm series Controller typeS / typeL Virtualization Functional Manual
11
2.3 Network
This section describes how to set the networks.
Correspondence with display of the Windows network adaptor and the LAN of PUB21
/ PUB21A are shown next.
Table 2.1 Windows Network Adaptor
Windows Network Adaptor
(default)
PUB21 display
PUB21A display
nV-Tool display
Ethernet
EN-B
LAN21
Ethernet 2
EN-A
LAN20
◆
Note
The IP addresses of the host (PLC / DCS) and the guest (Windows) to be assigned to the same
physical port shall be set to the same network address and different host addresses.
About the network configuration, refer to 1.3.