EasyManuals Logo
Home>Toshiba>Controller>Vm Series

Toshiba Vm Series Operating Instructions (Functional Manual)

Toshiba Vm Series
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
6F8C1657
ii
1. Safety Precautions in Installation
WARNING
Ground
Ground the device.
Otherwise, it may cause an electric
shock or fire.
CAUTION
Prohibited
Do not install, store, or use it in the
following places:
A place with a lot of dust
A place with corrosive gases (SO
2
,
H
2
S) or flammable gases
A place with vibrations and shocks
exceeding the allowed values
A place with condensations due to
rapid temperature changes
A place with low or high
temperature outside of the
installation condition
A place with high humidity outside
of the installation condition
A place with direct sunlight
A place near equipment
generating strong radio waves or
magnetic fields
It may cause accidents.
Mandatory
Install the device in a place where
maintenance and inspection can be
done easily.
Otherwise, it may cause accidents.
Prohibited
Do not block the ventilation hole or
air inlet/outlet.
It may cause fire or mechanical failure
due to overheat.
Mandatory
Install and wire the system by
following the installation conditions
and installation procedure described
in this document.
Otherwise, it may cause drop, fire,
mechanical failure or malfunction.
Prohibited
Do not install or store the relay
output module in the following
places:
Silicon gases are present.
Silicon products are used.
It may cause contact failure.
Prohibited
Do not put foreign matters such as
waste wire into the module or unit.
It may cause fire, mechanical failure or
malfunction.
Mandatory
Install the power module, CPU
module, and the expansion I/F
module on the base unit for the Vm
series because they are dedicated to
the Vm series.
Install TC-net I/O module on the base
unit for TC-net I/O.
Failure to observe this may cause electric
shock, injury, or mechanical failure.
Do not use it alone or for other purposes.
Mandatory
Turn off the power when installing or
removing the module, base unit or
terminal block.
Failure to observe this may cause electric
shock, malfunction, or mechanical failure.
Mandatory
Insert connectors, cables or the
module to the base unit until a clicking
sound is heard, and secure them with
screws tightly.
Insufficient tightening may cause
mechanical failure or malfunction due to
vibrations.

Other manuals for Toshiba Vm Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toshiba Vm Series and is the answer not in the manual?

Toshiba Vm Series Specifications

General IconGeneral
BrandToshiba
ModelVm Series
CategoryController
LanguageEnglish

Related product manuals