12
With its factory default settings, the Node is connected to
the Internet via its WAN port or a USB modem which can
the Node creates its own protected local network for the
Note:
•
connect a USB modem to the Node´s USB port.
•
Node.
CONNECTING NETWORK DEVICES TO THE NODE
4.1.1 DEPLOYING NODE IN “LOCK MODE”
1. Before connecting device to Node, connect to device per
device manufacturer’s instructions on your PC and assign a
IP address. We recommend adding the next IP sequential
address ABOVE the IP address on the Node, and so forth
2.
1.
2. Connect your PC to the Node´s service port and log in
following the step 1 on page 17 “Updating the Node
software”.
3.
device and change it if necessary.
4.
5. ADVANCED/ENTERPRISE USERS ONLY: Go to
that it’s higher than all used static addresses. Set the limit
unused addresses in the LAN range. For example, the range
192.168.5.50 – 192.168.5.254 contains 205 addresses so
4. TOSIBOX
®
LOCK INSTRUCTIONS
VPN tunnel
through Internet
TOSIBOX
®
Mobile
Client
TOSIBOX
®
Key
Firewall
TOSIBOX
®
Lock
HMI
PLC
Camera
PC
To Next Page
Loading...
Need help?
General
