21
LOCK 210, LOCK 250 AND LOCK 500
required to operate the Node. The power input port is
the sales package. Remove the connector if needed and
input port. It is recommended to wire this connection to the
to power the device. Follow the polarity and grounding
Make sure the connector is completely plugged in and
2
the connector. The stripping length of the conductor is 6
mm.
The Node is equipped with a 2 Amp internal fuse. In case of
In addition to the powering options for Lock 500, an
complies with your local requirements. The AC adapter
DC output connector is coaxial. Therefore, a conversion
version sales package. Follow the same procedure as with
Lock 500 powering options.
TOSIBOX
®
Use the AC adapter included in the sales package.
To Next Page
Loading...
Need help?
General
