2. Turn on the power.
1
Insert the power plug.
The wand extends and then retracts.
•
2
Check that the POWER LED
on the main display is lit up.
If the LED is not lit up, pressing [POWER
•
ON/OFF] will light it up.
3. Open the water supply valve.
1
Fully open the water supply
valve.
1. Insert the battery.
1
Remove the remote control
from the hanger.
2
Open the battery cover and
insert two AA batteries.
Battery cover
AA batteries x2
Close
Open
3
Mount the remote control in
the hanger.
About the batteries ■
Use dry cell, alkaline batteries. Follow the
●
instructions below to prevent the batteries from
rupturing or leaking fluid.
When replacing the batteries, use new batteries of
•
the same brand.
If you will not be using the remote control for a long
•
time, remove the batteries.
Do not use rechargeable batteries.
•
When the remote control is locked to
prevent theft
1
Remove the screw from the
remote control xture.
Phillips screwdriver
Screw
Hanger
Loosen
Wall
Remote control
(Side view)
2
Remove the remote control
from the hanger.
To return
●
Tighten the screw. (Overtightening may
•
cause damage to parts such as the hanger.)
Preparation
Using the Washlet for the First Time
To Next Page
Loading...
