TP-Link NC450 - Chapter 2 Get to Know Your Camera; 2.2.2 Rear Panel Appearance

NC450 HD Pan/Tilt Wi-Fi Camera with Night Vision
3
 System LED:
Status Indication
Flashing Red
The camera starts booting up.
Solid Red
The camera has boot up, but is not connected to any
network.
The camera is in firmware upgrade procedure.
Flashing Green
The camera is connecting to a network.
The camera is connected to a network.
Solid Green
The camera is transferring data.
 Microphone: The camera has a built-in internal microphone. This microphone is hidden in
the pinhole located on the front panel.
2.2.2 Rear Panel
Speaker
Internet PortMicro SD Card Slot Po
w
er Jack
WPS/Reset Button
Internet Power
WPS/
ResetMicroSD
Figure 2-2 Rear Panel
 Speaker: For audio output.
 Micro SD Card Slot: For holding the micro SD card.
 Internet Port: For connecting the camera to your router via an Ethernet cable.
 Power Jack: For connecting the camera to power socket via the provided power adapter.
 WPS/Reset Button: The switch for the WPS and Reset function. To use the WPS function,
press it for about 2 seconds. To use the Reset function, press and hold for more than 5
seconds.