2
Connect your telephone to the port labeled “PHONE 1~2” on the Modem
Router with a telephone line.
Connect your USB device to the USB port labled “USB 1~2” on the Modem
Router.
Plug the provided Power Adapter into the Power jack on the back of the
Modem Router and the other end to a standard electrical wall socket.
Power on all your network devices and then check to see if the LEDs of the
Modem Router display normally as the diagram below describes.
If the LEDs display abnormally, please check to see if all the cable
connectors (power adapter, phone line and Ethernet cable) are well
connected to your device. With the phone line well connected, if the
ADSL LED turns off after flashing, please contact your ISP to ensure that
your Internet connection is active.
Note
WLAN: Solid
light or flashing
USB: Solid
light or flashing
Note
If you want to share files or use the USB Voice Mail function, please plug
an external USB hard drive/USB flash disk into the USB port. To use the
printer function, please connect a USB printer to the USB port.
Line: Solid light
or flashing
LAN: Solid light
or flashing
ADSL: Solid
light or flashing
Power: Solid
li
ht
Note
To use USB Voice Mail function, please make sure the free space of the
plugged external USB hard drive/USB flash disk is more than 4MB.
To Next Page
Loading...
