1
If you currently use a modem, disconnect it now - the Modem Router will
replace your current modem.
Connect your computer to the port labeled “LAN 1~4” on the Modem Router
with an Ethernet cable.
Connet the LINE port on the splitter to the wall jack using a telephone line.
Then use the other telephone line to connect the MODEM port on the
splitter to the ADSL port on the Modem Router, also have the PHONE port
on the splitter connected to the LINE port of the Modem Router.
Note
Please use only wired network connections to configure the Modem Route
To Next Page
