Figure 3-6
Step 4: There are four connection types: Dynamic IP Address, Static IP Address, PPPoE/PPPoA
and Bridge Mode. Please choose the connection type that your ISP provides. After that,
you should follow the configuration below to proceed.
1) Select Dynamic IP Address in Figure 3-6, the next screen will appear as shown in
Figure 3-7. Configure the following options provided by your ISP: VPI, VCI and
Connection Type. Then click NEXT.
Figure 3-7
2) Select Static IP Address in Figure 3-6, the next screen will appear as shown in
Figure 3-8.Configure the following options provided by your ISP: VPI, VCI, IP
Address, Subnet Mask, ISP Gateway and Connection Type. Then click NEXT.
13
To Next Page
Loading...
