11n Settings: These are the settings of the 11n parameters. If “802.11n” or “802.11b+g+n” is
selected for Wireless mode, these settings will be displayed.
• Channel Bandwidth: Select the Bandwidth you want to use from the drop-down List.
There are three options: “20 MHz”, “Auto” and “40 MHz”. If bigger bandwidth is selected,
device could transmit and receive data with higher speed. The default value is Auto.
• Extension Channel: If “Auto” is selected, this option will be displayed.
• Guard Interval: Select the guard interval you want from the drop-down list.
• MCS: Select the wireless transmission rate from the drop-down list. By default, the option
is AUTO.
Multiple SSIDs Settings: These are the settings of the SSID.
• SSID Index: The index of the SSID. In this model, you can leave it as a default value of 1.
• Broadcast SSID: When wireless clients survey the local area for wireless networks to
associate with, they will detect the SSID broadcast by the modem router. To broadcast
the modem router’s SSID, keep the default setting. If you don’t want to broadcast the
modem router’s SSID, select “No”.
• Use WPS: Use WPS (Wi-Fi Protected Setup) function, you can add a new wireless
device to an existing network quickly. To Use WPS, keep the default setting, and
configure the parameters in WPS Settings. If you don’t want to Use WPS, select “No”,
then you will see the screen as shown below.
Figure 4-19
• SSID: Wireless network name shared among all points in a wireless network. The SSID
must be identical for all devices in the wireless network. It is case-sensitive and must not
exceed 32 characters (use any of the characters on the keyboard). Make sure this setting
is the same for all stations in your wireless network. Type the desired SSID in the space
provided.
• Authentication Type: Select an authentication type from the drop-down list, which
allows you to configure security features of the wireless LAN interface. Options available
are: Disabled, WEP-64Bits, WEP-128Bits, WPA-PSK, WPA2-PSK, and WPA-PSK/
WPA2-PSK. The default Authentication Type is WPA2-PSK.
1) WEP-64Bits
39
To Next Page
Loading...
