22
Servicename: Enter a name to mark current connection, or you can leave it blank.
Username: Enter your username for your PPPoA/PPPoE connection.
Password: Enter your password for your PPPoA/PPPoE connection.
Encapsulation: For both PPPoA and PPPoE connection, you need to specify the type
of Multiplexing, either LLC or VC Mux.
Bridge Interface: Activate the option, and the modem router can also work in Bridge
mode.
Connection: For PPPoA/PPPoE connection, you can select Always On or Connect
On-Demand
or Connect Manually. Connect On-Demand is dependent on the traffic. If
there is no traffic (or
Idle) for a pre-specified period of time, the connection will tear
down automatically. And once there is traffic send or receive, the connection will be
automatically on.
TCP MSS Option: Enter the TCP MSS as your desire.
Default Route: You should select
Yes to configure the PVC as the default gateway to
internet from this device.
Get IP Address: Select Static or Dynamic. For PPPoA/PPPoE connection, you need to
specify the public IP address for this ADSL modem router. The IP address can be
either dynamically (via DHCP) or given IP address provided by your ISP. For Static IP,
you need to specify the IP address, Subnet Mask and Gateway IP address.
To Next Page
Loading...
