59
4.4.3 SNMP
Go to Access Management → SNMP, you will see the SNMP screen. The Simple Network
Management Protocol (SNMP) is used for exchanging information between network devices.
Get Community: Set the password for the incoming Get and Get next requests from the
management station.
Set Community: Set the password for incoming Set requests from the management
station.
4.4.4 UPnP
Go to Access Management → UPnP, you can configure the UPnP in the screen.
UPnP (Universal Plug and Play) is a distributed, open networking standard that uses TCP/IP for
simple peer-to-peer network connectivity between devices. An UPnP device can dynamically
join a network, obtain an IP address, convey its capabilities and learn about other devices on
the network. In turn, a device can leave a network smoothly and automatically when it is no
longer in use. UPnP broadcasts are only allowed on the LAN.
UPnP: Activate or deactivate the UPnP function. Only when the function is activated can
the UPnP take effect.
Auto-configured: If you activate the function, the UPnP network devices can
automatically configure network addressing, announce their presence in the network to
other UPnP devices and enable exchange of simple product and service descriptions.
To Next Page
Loading...
