54
Select IP as the Rule Type on the Filter screen, then you can configure the specific
rule for the example.
Step 2: Select IP/MAC Filter Set Index and IP/MAC Filter Rule Index for the rule, then select
the Interface
PVC0, and select the Direction Both for the first rule.
Note:
If you want to make the rule take effect, please select Yes to active the rule.
Step 3: Enter the Source IP Address, Destination IP Address, Subnet Mask and Port Number
in the corresponding field.
Step 4: Select the Protocol as TCP and select the Unmatched rule as Next.
Step 5: Finally, click SAVE to save the entry.
Step 6: Go to Step 2 to configure the next two rules: Block E-mail received by the IP address
192.168.1.7 on your local network; Make the PC with IP address 192.168.1.8 unable to
visit the website of IP address 202.96.134.12.
Note:
After you complete the IP filter rules for the example, the Filter list will show as follows. You can
enter the
IP / MAC Filter Set Index to view the information about the rule.
To Next Page
Loading...
