If you don’t need the phone service, just skip step 1 and directly connect the
modem router to the phone jack with a phone cable, then follow steps 3 and 4 to
complete the hardware connection.
If you already have a modem or your internet comes directly from an Ethernet wall
outlet, you can switch to Wireless Router mode. Refer to the Already Have a
Modem? section on the back page.
Connect the Hardware 1
Quick Installation Guide
* Images may dier from actual products.
Wireless N USB VDSL/ADSL Modem Router
Notes:
1) The DSL LED takes about 1 to 2 minutes to stabilize.
2) If the Wi-Fi LED is off, please press the WiFi button on the
rear panel for about 1 second, then the LED should turn stable
in a few seconds.
Wi-Fi
On
Power
On
DSL
On
4
Verify that the hardware connection is correct
by checking these LEDs.
DSL Splitter
Phone Jack
Power Adapter
Modem Router
PHONE MODEM
LINE
Connect to the phone (Optional)
3
Connect the power adapter to the
modem router and push in to turn on
the modem router.
2
Connect the modem router to
the DSL splitter.
1
Connect the DSL splitter
to the phone jack.