7. TCP/IP LPR Port Printing Installation
Basic TCP/IP Installation Overview
selec
e de
1. Use the PSAdmin utility.
Manually specify (using DOS commands or UNIX text-mode commands. This
When installing your print server in a TCP/IP environment, IP addresses are essential as a
basic means of communications. It is therefore necessary to first assign an IP address to
your print server unit. After assigning an IP address, the print server can be configured
ccordingly. a
Assigning an IP Address
The first step to install a print server on a TCP/IP network is to assign the print server an IP
address and other related TCP/IP settings before the print server can function. You can
t the following two methods to specify an IP address the print server. Each method will
tailed in the following section. b
2.
applies to Windows NT/2000/XP/2003 and UNIX systems).
Note: The Network Print Monitor can only search for the print server(s) over the same
network segment the Windows NT/2000/XP/2003/UNIX computer is located. You
would like to install a print server on a different network segment.
DHCP
rint server to obtain an IP address and
erver. While the print server supports
ommend you manually specify a fixed IP address to the print server.
rver’s DHCP function is disabled.
Port Printing Installation
1. Click Start, point to Settings, and select Printer.
2. Run Add Printer.
3. The Add Printer Wizard screen will appear, Select My Computer and click Next.
The print server supports DHCP feature, allowing the p
lated TCP/IP settings automatically from a DHCP sre
DHCP, we strongly rec
y default, the print seB
Windows NT LPR
51
To Next Page
Loading...
