Need help?Do you have a question about the TP-Link TL-PS110P and is the answer not in the manual?
General| Networking standards | IEEE 802.3 |
|---|---|
| Network connection type | Ethernet LAN |
| Supported network protocols | TCP/IP, IPX/SPX, NetBEUI, Apple Talk, LPR, IPP/SMB, RAW, TCP |
| Interface | IEEE 1284 |
| Dimensions (WxDxH) | 59 x 52 x 22 mm |
| Power requirements | 3.3V DC 2A |
| Compatible operating systems | Windows 9X/Me, Windows NT/2000/2003/XP/Vista, Mac OS 8.0, UNIX/Linux, Netware 3.12 |
| Non-operating relative humidity (non-condensing) | 0 - 80 % |
| DC-in jack | Yes |
| Ethernet LAN (RJ-45) ports | 1 |
| Storage temperature (T-T) | -5 - 65 °C |
| Operating temperature (T-T) | 0 - 50 °C |
| Operating relative humidity (H-H) | 0 - 70 % |
| Certification | FCC, CE |
Provides step-by-step instructions for physical installation.
Guides on installing the PSAdmin utility and print server driver.
Explains how to use the PSAdmin utility for management.
Introduces the wizard for print server configuration.
Explains prerequisites and steps to use the web server.
Details how to install the TCP/IP protocol on Windows.
Describes methods for assigning an IP address to the print server.
Guides on installing LPR port printing on Windows NT.
Guides on installing Standard TCP/IP port printing on Windows 2000/XP/Vista.
Explains firmware upgrade using the PSAdmin utility.
Guides firmware upgrade via TCP/IP on Windows systems.
Details firmware upgrade via TCP/IP on UNIX systems.
Explains firmware upgrade using the web browser interface.
Addresses issues concerning the power adapter and voltage.
Discusses failures related to the parallel port connection.
Addresses common TCP/IP connectivity and configuration problems.
Steps to reset the print server to factory default settings.
To Next Page
