-36-
Password:
Enter the Password provided by your ISP. If you are not clear, please
consult your ISP.
Auth Server:
Enter the address of authentication server. It can be IP address or
server name.
Auth Domain:
Enter the domain name of authentication server. It's only required when
the address of Auth Server is a server name.
Auth Mode:
You can select the proper Active mode according to your need.
z Manual: Select this option to manually activate or terminate the
Internet connection by the <Connect> or <Disconnect> button. It’s
optimum for the dial-up connection charged on time.
z Always-on: Select this option to keep the connection always on.
The connection can be re-established automatically when it is
down.
MTU:
MTU (Maximum Transmission Unit) is the maximum data unit
transmitted by the physical network. It can be set in the range of
576-1500. The default MTU is 1500.
Upstream/Downstream
Bandwidth:
Specify the Upstream/Downstream Bandwidth for the port. To make
"Load Balance" and "Bandwidth Control" take effect, please set these
parameters correctly.
¾ BigPond Status
Status:
Displays the status of BigPond connection.
z “Disabled” indicates that the BigPond connection type is not
applied.
z “Connecting” indicates that the Router is obtaining the IP
parameters from your ISP.
z “Connected” indicates that the Router has successfully obtained
the IP parameters from your ISP.
z “Disconnected” indicates that the connection has been
manually terminated or the Router gets no response from your
ISP. Please ensure that your settings are correct and your
To Next Page
Loading...
Need help?
General
