TL-WA701ND 150Mbps Wireless N Access Point User Guide
Appendix C: Troubleshooting
T1. How do I restore my Access Point’s configuration to its factory default settings?
With the Access Point powered on, use a pin to press and hold the RESET button on the rear
panel for more than 8 seconds before releasing it.
)
Note:
Once the Access Point is reset, the current configuration settings will be lost and you will need
to reconfigure the Access Point.
T2. What can I do if I forget my password?
1) Restore the Access Point’s configuration to its factory default settings. If you don’t know
how to do that, please refer to previous section T1;
2) Use the default user name and password: admin, admin;
3) Try to reconfigure your AP by following the instructions of this UG.
T3. What can I do if I cannot access the web-based configuration page?
Assign a static IP address 192.168.0.100 for your computer first before logging in the
management page. Here takes the procedures in Windows 7 for example.
1) Go to Start > Settings > Control Panel, and then Click View network status and
tasks.
69
To Next Page