2) Immediately press the RE button on your extender. The RE
LED should change from blinking to solid, showing that WPS
connection is successful.
3 Relocate
Plug the extender into an electrical outlet about halfway between your
router (Host Network) and the Wi-Fi dead zone.
Wait until the (Signal Strength) LEDs are lit. Make sure the extender
is in a location with 3 or more LEDs lit. If not, relocate the extender closer
to the router to achieve a good (or better) signal quality.
Enjoy!
The extender shares the same wireless network name (SSID) and wireless
password as your router.
For more information about using WPS on your router,
please refer to the router manufacturer's user guide.
If the RE LED does not change from flashing to solid,
please refer to Using your Web Browser
.
Some ISP gateways disable the WPS function by
default, if the WPS method fails, please refer to
Using
your Web Browser.
Connect the Extender to the Internet 6
To Next Page
Loading...
