149
Chapter 7
Configure the Router in Range Extender Mode
7. 4. 3. Wireless MAC Filtering
Wireless MAC Filtering is used to deny or allow specific wireless client devices to access
your network by their MAC addresses.
I want to:
Deny or allow specific wireless client devices to access my network by their MAC
addresses.
For example, you want the wireless client A with the MAC address 00:0A:EB:B0:00:0B
and the wireless client B with the MAC address 00:0A:EB:00:07:5F to access the router,
but other wireless clients cannot access the router
How can I do that?
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Wireless > Wireless MAC Filtering.
3. Click Enable to enable the Wireless MAC Filtering function.
4. Select Allow the stations specified by any enabled entries in the list to access as the
filtering rule.
5. Delete all or disable all entries if there are any entries already.
6. Click Add New and fill in the blank.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
