Figure 2-2 Hardware Installation of the TL-WR802N in AP Mode
1. Connect the LAN or LAN/WAN port of TL-WR802N to the wired network port with an Ethernet
cable.
2. Connect TL-WR802N to the power.
3. Power on the PC(s) and notebook(s).
2.3.3 Repeater Mode
TL-WR802N is used to extend the range of wireless signal of the existing AP or wireless router.
On this mode, the wired port LAN/WAN works as LAN. Computer could connect to the device by
either wired or wireless way. The SSID of TL-WR802N should be the same as that of the device
you repeat.
Figure 2-3 Hardware Installation of the TL-WR802N in Repeater Mode
1. Connect TL-WR802N to the power.
- 7 -
To Next Page
Loading...
