country or region is not listed, please contact your local government agency for
assistance.
WDS Mode - In WDS Repeater mode, the AP with WDS enabled will relay data to an
associated root AP. AP function is enabled meanwhile. The wireless repeater relays
signal between its stations and the root AP for greater wireless range. Please input the
MAC address of root AP in the field "MAC Address of Root AP".
Wireless Security Mode - This option should be chosen according to the security
configuration of the AP you want to access. It is recommended that the security type is
the same as your AP’s security type.
Wireless Password - If the AP your router is going to connect need password, you
need to fill the password in this blank.
2. Click Survey button on the Wireless page as shown in Figure 3-17, and then AP List page will
appear as shown in Figure 3-18. Find the SSID of the Access Point you want to access, and
click Connect in the corresponding row. For example, the second item is selected. The target
network’s SSID will be automatically filled into the corresponding box which is shown as the
Figure 3-17.
Figure 3-18 AP List
Note:
If you know the SSID of the desired AP, you can also input it into the field "SSID" manually.
3. Click the Next button in Figure 3-17. You will then see the Finish page.
Because something has changed on the Wireless Repeater page, you will see the Finish
page as shown in Figure 3-19. Click the Reboot button to make your wireless configuration
take effect and finish the Quick Setup.
- 21 -
To Next Page
Loading...
