TP-Link WBS210 - Page 117

113
Simple Network Management Protocol (SNMP) is an application layer protocol that facilitates
the exchange of management information between network devices. Main functions of SNMP
LQFOXGHPRQLWRULQJQHWZRUNSHUIRUPDQFHGHWHFWLQJDQGDQDO\]LQJQHWZRUNHUURUFRQƮJXULQJ
network devices, and so on.
Configure the device as SNMP Agent, and it can receive and process the management
message from the NMS (Network Management System).
Go to the 0DQDJHPHQW page. In the 6103$JHQW section, configure the following
parameters and click
Apply .
SNMP Agent Enable or disable the SNMP Agent function.
SysContact Enter the textual identification of the contact person for this device, for
example, contact number or e-mail address.
SysName Enter a name for the device.
Syslocation Enter the location of the device. For example, the name can be
composed of the building, floor number, and room location.
Get Community Specify the community that has read-only access to the device’s SNMP
information.
Get Source Enter the IP address of the NMS that can serve as Get Community to
read the SNMP information of this device. By default, it is 0.0.0.0, which
means an NMS of any IP address is available.
Set Community Specify the community who has the read-and-write right of the device’s
SNMP information.
Set Source Enter the IP address of the NMS that can serve as Set Community to
read and write the SNMP information of this device. By default, it is
0.0.0.0, which means an NMS of any IP address is available.
Click Apply , then click Save .