TP-Link WBS210 - Page 45

41
MAXtream Displays the status of the MAXtream function. This function is only available
in Access Point Mode and AP Router Mode. MAXtream is a TP-Link
proprietary technology. It is based on TDMA (Time Division Multiple Access)
so that data streams are transmitted in their own time slots. MAXtream aims
to maximize throughput and minimize latency. “Hidden nodes” problem can
also be eliminated with MAXtream enabled.
1RWH
MAXtream Technology is only compatible with Pharos series products.
Working with products from other manufacturer will cause network fault.
Region Displays the region where you use the device. Available channels and
maximum Transmit Power will be determined by the selected region
according to the local laws and regulations.
Channel/
Frequency
Displays the channel and frequency which are currently used by the device.
Channel Width Displays the channel width which is currently used by the device.
IEEE802.11
Mode
Displays the IEEE802.11 protocol currently used by the device.
Max TX Rate Displays the maximum data rate of the device during the sending of the
wireless packets.
Antenna Displays the antenna that you use.
Transmit Power Displays the transmit power which is currently used by the device.
Distance Displays the wireless coverage distance. In the coverage of the device, the
clients can be placed to get good wireless performance.
3.3 9LHZ:LUHOHVV6LJQDO4XDOLW\
Go to the STATUS page. In the :LUHOHVV6LJQDO4XDOLW\ section, view the current signal
quality of the upstream wireless network. It is only applicable for the Client, Repeater,
Bridge and AP Client Router (WISP Client) Modes.