Basic safety instructions
Printed in the Federal Republic of Germany © TR-Electronic GmbH 1997, All Rights Reserved
03/04/2010 TR - ECE - BA - GB - 0009 - 08 Page 7 of 45
1.3 General risks when using the product
The product, hereinafter referred to as "the measuring system", is manufactured
according to state-of-the-art technology and accepted safety rules. Nevertheless,
improper use can pose a danger to life and limb of the user or third parties, or
lead to impairment of the measuring system or other property!
Only use the measuring system in a technically faultless state, and only for its
designated use, taking safety and hazard aspects into consideration, and observing
this User Manual! Faults which could threaten safety should be eliminated without
delay!
1.4 Proper use
The measuring system is used to measure angular motion and to condition the
measurement data for the subsequent control of industrial control processes.
Proper use also includes:
• observing all instructions in this User Manual,
• observing the nameplate and any prohibition or instruction symbols on the
measuring system,
• observing the enclosed documentation, e.g. product insert, connector
configurations etc.,
• observing the operating instructions from the machine or system manufacturer,
• operating the measuring system within the limit values specified in the technical
data.
The following areas of use are especially forbidden:
• in environments where there is an explosive atmosphere
• for medical purposes
To Next Page
Loading...
