Trace Engineering RC7 Manual

You can switch the meter display from a per-cent-of-capacity to a ‘empty-full’ bar graph
scale, both illustrated above. To switch from one display to the other, just press the Settings
key when the SOC meter is displayed.
This meter displays the estimated hours and tenths of hours (six minutes) that the batteries
will support the present load before requiring charging.
Displays the estimated hours and tenths of hours required to charge the batteries to full
capacity.
You can manually start or stop the generator (RC7GS only) at anytime by scrolling the
display to this item and then pressing the On/Off button on the RC7GS faceplate.
Time Left to Run
Time Left to Charge
Generator Start/Stop
Time Left toChg
0.0 Hours
Gen Start/Stop:
Press (On/Off)
Time Left To Run
0.0 Hours
15
Genstart 2
Not Used
Genstart 1
Genrun 2
Genrun 3
Genrun 1
Copyright Trace Engineering Co. Inc. Tel (360) 435-8826 Part Number 822-4
5916 195 Street, NE Fax (360)435-2229 Effective: November 1, 1997
Arlington, WA 98223 USA www.traceengineering.com Page

th

Trace Engineering RC7 Specifications

General

Brand	Trace Engineering
Model	RC7
Category	Remote Control
Language	English