Trace Engineering RC7 Manual

17
System Status:
Float Charging
System Status:
AbsorptionChg
System Status:
Bulk Charging
System Status:
Searching
System Status:
Inverting
AC Source Error ModeCharger ModeInverter Mode
System Status:
Gen
Wont start
System Status:
Waiting for AC
System Status:
AC Available
System Status:
Cranking Genset
System Status:
PendingGenstart
Genset Status:
Starter
Cooldown
System Status:
Gen Quiet Fault
System Status:
Low Genset Volts
System Status:
Lobat Start Charge
System Status:
Hibat Stop Charge
System Status:
Oload/Less Load
System Status:
Otemp/Less Load
RC7GS Only
Meters Display
FET Temp:
000 counts
Est. Bat. Cap:
47 Amp-hrs(x8)
Xformer Temp:
000 counts
Pass-thru Amps:
0 Amps AC
Battery Temp
000 counts
AC Input
000 Vac 000 Vpk
AC Output:
000 Vac
AC Input:
0 Amps AC
Avg Shunt Amps
-/+ 0 Amps DC
Battery:
00.0 Volts DC
Inv/Chg Current:
+/- 0 Amps DC
System Status Messages
Bat State Of
Chg
XX% of Full
Time Left toChg
X.X Hours
Time Left To Run
X.X Hours
Gen Start/Stop:
Press (On/Off)
Bat State Of
Chg
EF
Operating Display
The arrow enables you to move
across the columns. The Up and
Down arrows enable you to scroll through
the headings along the left column.
Settings
Menu
Copyright Trace Engineering Co. Inc. Tel (360) 435-8826 Part Number 822-4
5916 195 Street, NE Fax (360)435-2229 Effective: November 1, 1997
Arlington, WA 98223 USA www.traceengineering.com Page

th

Trace Engineering RC7 Specifications

General

Brand	Trace Engineering
Model	RC7
Category	Remote Control
Language	English