5
w WARNING
If the re in the repot goes out while
cooking, it is important to follow these steps. Failure to
do so may cause a hazardous “overring” of your grill
due to an excess of unburned pellets in the repot. This
is often caused by improper start-up procedure and/or
running out of pellets.
• Turn the main power switch in the back of the grill
hopper to OFF (O) and disconnect the power cord.
Allow the grill to cool thoroughly. Open the door and
remove all food, grill grates, drip tray, and heat bafe.
• Remove all unburned pellets and ash from inside
and around the repot. (See instructions for proper
handling and disposal of ash on page 31.)
• Before replacing the heat bafe, drip tray, and grill
grates, plug the power cord into an appropriate
grounded/earthed electrical outlet and turn the main
power switch to ON (I). Pellets should fall into the
repot and the hot rod should begin to heat (it will start
to turn red).
w WARNING
Do not touch the hot rod.
• When ames start to come out of the repot, turn the
main power switch to OFF (O). Let the grill cool down.
Now you’re ready to place the heat bafe, grease
drip tray, grill grates, and food back into the grill.
w WARNING
• Turn the main power switch to OFF (O) and
disconnect the power cord before initiating any
maintenance.
• Accumulated grease is easier to clean off when
the grill is still warm—not hot. Be careful not
to burn yourself. Heat-protective gloves are
recommended.
• A dedicated vacuum cleaner is the best way to
remove ashes from the repot, but this must be done
with extreme care to avoid the risk of re. Again,
cleaning the ash from in and around the repot
should be done only when the grill is COLD.
• Cleaning the grill grates works best while they
are still warm. Be careful not to burn yourself.
Heat-protective gloves are recommended. We
recommend keeping a long-handled cleaning brush
near the grill. After removing your food, give the grill
grate a quick brushing. It takes only a minute and it
will be ready the next time you want to use the grill.
This equipment has been tested and found to comply
with the limits for Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on. The user is
encouraged to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
–
Increase the separation between the equipment
and the receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected. Consult the dealer or an experienced
radio/TV technician for help.
– For additional information please contact
Traeger’s Compliance Engineer at
compliance@traeger.com or 1215 E. Wilmington
Ave, Suite 200, Salt Lake City, UT 84106
SAVE THESE INSTRUCTIONS
T09627_Redland_OM_EN.indd 5T09627_Redland_OM_EN.indd 5 9/16/22 10:58 AM9/16/22 10:58 AM
This device complies with Part 15 of the FCC rules.
Operation is subject to the following conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference recieved,
including interference that may cause undesired
operation
To Next Page
Loading...
