Traeger REDLAND - Seasoning Your Grill; Initial Auger Priming Procedure

14
SEASONING YOUR GRILL
TO BE USED ON INITIAL FIRING ONLY. In order to ensure proper and safe operation of the grill, follow the instructions below,
first, to prime the auger (“charge” the auger tube with pellets) and, second, to season your grill (run your grill at a high temperature).
2
PLUG APPEARANCE MAY VARY BY REGION.
With the main power switch on the back of the grill hopper in the
OFF (O) position, plug the power cord into an appropriate grounded/
earthed GFCI electrical outlet.
3
Open the hopper lid. Make sure there are no foreign objects in the
auger before adding pellets to the hopper. Afer adding pellets to the
hopper, close the hopper lid. We recommend you fill the hopper with
pellets at least to the safety grate in the hopper.
PRIME AUGER
>Done
Auger Priming
02:20
AUGER
>Prime Auger
>Clear Auger Jam
>Back
Turn grill on: Flip the main power switch on the back of the grill to
ON (I); then press the Standby button to wake the grill. Press MENU
to display the main menu. Turn the dial to select AUGER, then select
Prime Auger.
The auger tube will take a few minutes to fill with pellets and begin
dispensing into the firepot. Your grill display will tell you the specific
time. To confirm that pellets have reached the firepot, simply check
to see that they are moving from the auger tube into the firepot. You
only need a few pellets in the firepot to properly ignite your grill and
begin the seasoning process. Select Done.
4
1
Remove the grill grates, grease drip tray, and heat bae from the
inside of the grill.
T09627_Redland_OM_EN.indd 14T09627_Redland_OM_EN.indd 14 9/16/22 10:59 AM9/16/22 10:59 AM