Trakm8 T10-Micro - USA and Canada Approval; VCA Approval

T10 Installation Notes v1.7
Generic T10 Installation Notes v1.7.doc 12.08.2015
Page 7
USA and Canada Approval
 FCC – Marking (T10-Micro)
The T10-Micro complies with Part 15 of the FCC Rules and contains the following
markings.
FCCID:SMGT10MICROBLE
Operation of the product is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that
may cause undesirable operation.
 IC – Marking (T10-Micro)
The T10-Micro complies with Industry Canada licence exempt RSS Standard(s) and
contains the following markings:
IC:20171-T10MICROBLE
Operation of the product is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that
may cause undesirable operation.
VCA Approval
 “E” – Marking (T10-Micro 2 Tier)
The T10-Micro has been approved by the VCA directive for automotive use in
accordance with EMV 2004/104/EG and contains the following marking:
 “E” – Marking (T10-Micro 3 Tier)
The T10-Micro 3 Tier is currently undergoing approvals.
 “E” – Marking (T10-MiniLite/T10-Lite 3/5 wire)
The T10-Lite 3/5 wire has been approved by the VCA directive for automotive use in
accordance with EMV 2004/104/EG and contains the following marking:
This product was formerly known as T10-MiniLite and has now been bannered under the
T10-Lite group as a 3 wire or 5 wire device.
 “E” – Marking (T10-Lite 9 wire)
The T10-Lite 9 wire has been approved by the VCA directive for automotive use in
accordance with EMV 2004/104/EG and contains the following marking: