T10 Installation Notes v1.7
Generic T10 Installation Notes v1.7.doc 12.08.2015
Page 8
4 The T10 Family
The T10 family consists of a range of products to meet the demanding requirements of modern
day telematics.
In summary these variations have been categorised into two sub families called:
a. T10-Micro
b. T10-Lite (2/3/5/9 wire)
4.1 T10-Micro
The T10-micro is a plug and play product designed to be inserted into the vehicle ECU Diagnostic
socket (J1962) which usually is accessible within the driver cockpit area and can be accessed
without the need of specialised tools. This product does not require the involvement of a
specialised fitter and can usually be fitted by the end user. Units that are supplied with a
customer SIM fit option should follow the same SIM fitting process as described for the T10-Lite.
4.2 T10-Lite
The T10-Lite exists as 4 variants (2wire, 3wire, 5wire, 9wire) and requires the specialised
knowledge of fitting electrical equipment to vehicles. The T10-Lite 2/3/5wire devices (formerly
known as T10-MiniLite) which are very similar in size to the T10-Lite 9 wire product but contain
the following additional hardware features over the T10-Lite 2/3/5wire device:
1. A larger backup battery (1500mAH).
2. Addition of a Driver Interface Button (Cable CAB601).
3. Addition of a Driver Identification Dallas interface (Cable CAB700).
4. Addition of an Output to drive an immobilisation relay.
5. Addition of a PTO Input (NONE CAN variant ONLY).
6. Additional CAN Protocols (ISO 9041, KW2000)
5 Installation
5.1 T10-Lite Variants
Before you begin installing and commissioning the system please ensure that you have read this
manual thoroughly referring to any supplementary information provided for the T10 as required.
This document covers the T10 platform Control Unit and its connections through the following
process:
1. Recommended Sequence
2. Fitting the SIM
3. Mounting the Unit
4. Wiring and connections
i. Power, Ground and Ignition (ALL variants ex 2wire – Power/Ground ONLY)
ii. CAN (T10-Lite 5 wire & 9wire)
iii. Driver Button (T10-Lite 9 wire ONLY)
iv. Driver Identification (T10-Lite 9 wire ONLY)
v. PTO Input (T10-Lite 9 wire ONLY)
vi. Output (T10-Lite 9 wire ONLY)
To Next Page
Loading...