CONCRETE MOISTURE ENCOUNTER X5 USER GUIDE
14
Calibration
For regular on-site assessment of your Concrete
Moisture Encounter X5 in moisture measurement mode,
a calibration-check plate is available from the suppliers
of your Concrete Moisture Encounter X5. Should it
be found that readings are outside the set tolerances,
it is recommended that the Concrete Moisture
Encounter X5 be returned for re-calibration. Calibration
adjustments should not be carried out by anyone other
than Tramex or their authorized service provider who
will issue a calibration certificate on completion.
Requirements for quality management and validation
procedures, such as ISO 9001 and National Standards,
have increased the need for regulation and verification
of measuring and test instruments. It is therefore
recommended that calibration of the Concrete Moisture
Encounter X5 should be checked and certified in
accordance with the standards and/or protocols laid
down by your industry (usually on an annual basis) by an
authorised test provider. The name of your nearest test
provider and estimate of costs are available on request.
To Next Page
Loading...
Need help?
General
