CONCRETE MOISTURE ENCOUNTER X5 USER GUIDE
51
LIMITATIONS
The Concrete Moisture Encounter X5 will not detect or
measure moisture through any electrically conductive
materials including metal sheeting or cladding, many
types of black EPDM rubber or wet surfaces. The
Concrete Moisture Encounter X5 is not suited for taking
comparative readings in the concrete substrate through
thick floor coverings such as wood.
CALIBRATION
For regular on-site assessment of your Concrete
Moisture Encounter X5 in moisture measurement
mode, a calibration-check plate is available from the
suppliers of your Concrete Moisture Encounter X5.
Should it be found that readings are outside the set
tolerances, it is recommended that the Concrete
Moisture Encounter X5 be returned for re-calibration.
Calibration adjustments should not be carried out by
anyone other than Tramex or their authorised service
provider who will issue a calibration certificate on
completion. Requirements for quality management and
validation procedures, such as ISO 9001, have increased
the need for regulation and verification of measuring
and test instruments. It is therefore recommended that
calibration of the Concrete Moisture Encounter X5
should be checked and certified in accordance with the
standards and/or protocols laid down by your industry
(usually on an annual basis) by an authorized test
provider. The name of your nearest test provider and
estimate of cost is available on request.
To Next Page
Loading...
Need help?
General
