18-GJ89D1-1E-EN
13
Placing Unit at Location
1. Carry the unit to the installation location
2. Reassembly by reversing the steps listed in Section 4 if
disassembly was required. If cut, wire ties that held the sensor
wiring must be replaced.
Important: Under no conditions should metal strapping be attached
to the unit to be used as support mechanisms for carrying
or suspension purposes.
Approved Carrying:
• Hold by the cross members within the cabinet or unit top plate and
use as handles for lifting and carrying the coil and blower sections.
To Next Page
Loading...
Need help?
General
