Trane 4TCC4024A1000A User Manual

SSAAFFEETTYYWWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
June 2020
1188--EEBB3300DD11--11GG--EENN
Single Packaged Cooling/Electric Heat
14 SEER Convertible, 2 — 5 Ton
4TCC4024A1000A
4TCC4030A1000A
4TCC4036A1000A
4TCC4042A1000A
4TCC4048A1000A
4TCC4060A1000A
NNoottee:: “Graphics in this document are for representation only. Actual
model may differ in appearance.”
Installer’s Guide

Trane 4TCC4024A1000A Specifications

General

Cooling Capacity	24000 BTU/H
Tonnage	2 Ton
SEER	14
HSPF	8.2
Refrigerant	R-410A
Voltage	208/230V
Phase	1
Type	Air Source
Heating Capacity	24000 BTU/h

Summary

Safety Section

Introduction

Step 1 Inspect Shipment

Check for damage, verify unit specifications, and ensure refrigerant charge retention after unloading.

Step 2 Determine Unit Clearances

Provides diagrams and tables detailing unit dimensions, required clearances, and weight for different models.

Step 3 Review Location and Recommendation Information

Guidelines for unit placement, service clearances, and specific considerations for horizontal and down airflow units.

Step 4 Unit Installation

Details procedures for ground level, rooftop curb, and frame mounting, including ductwork and wiring.

Step 5 Unit Startup

Checklist for pre-start checks, cooling/heating mode startup, and essential operating parameter verification.

Sequence of Operation

Describes the automatic cycles for cooling, heating, supplementary heat, and demand defrost mechanisms.

Maintenance

Outlines owner maintenance tasks and recommends professional service checks for optimal system operation.

Important Product Information

Section for recording unit serial number, model number, installation date, and dealer contact information.