Trane 4TCC4036A1000A User Manual

SSAAFFEETTYYWWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
June 2020
1188--EEBB3300DD11--11GG--EENN
Single Packaged Cooling/Electric Heat
14 SEER Convertible, 2 — 5 Ton
4TCC4024A1000A
4TCC4030A1000A
4TCC4036A1000A
4TCC4042A1000A
4TCC4048A1000A
4TCC4060A1000A
NNoottee:: “Graphics in this document are for representation only. Actual
model may differ in appearance.”
Installer’s Guide

Trane 4TCC4036A1000A Specifications

General

SEER Rating	14
HSPF Rating	8.2
Refrigerant	R-410A
Voltage	208/230V
Phase	1
Cooling Capacity	36000 BTU/h
Heating Capacity	36000 BTU/h

Summary

Safety Section

Hazardous Voltage and Electrical Hazards

Covers warnings related to high voltage, electrical shock, and proper servicing procedures.

Refrigerant and Operational Safety

Details grounding requirements and R-410A refrigerant handling safety precautions.

Chemical Exposure and General Safety

Highlights hazards from operating without access panels and chemical exposure warnings.

Unit Installation

Ground Level Installation Procedures

Procedures for installing the unit on a ground level pad, including clearance and duct connections.

Rooftop Installation: Airflow Conversion and Curb Mounting

Steps for converting airflow and installing roof curbs for rooftop units.

Lifting and Rigging Procedures

Safe practices for lifting and rigging the unit, including using the correct accessory kit and spreader bars.

Mounting the Unit on the Curb

Instructions for positioning and securing the unit onto the mounting curb.

Rooftop Installation: Frame Mounting (Curb)

Rooftop Installation: Frame Mounting (Sleeper Rails)

Ductwork Installation

Downflow Ductwork Attachment

Horizontal Ductwork and Condensate Piping

Air Filter Installation

Electrical Wiring

Electrical Connections, Power, and Safety

Control Wiring (Class II)

Unit Startup

Pre-Start Checklist and Cooling Mode Startup

Operating Checks and Cooling Shutdown

Heating Mode Startup and Shutdown

Sequence of Operation

Maintenance