Trane 4TWV0036A1000A User Manual

SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and
air-conditioning equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered
equipment by an unqualified person could result in death or serious injury. When working on the equipment, observe all precautions in the
literature and on the tags, stickers, and labels that are attached to the equipment.
October 2014
18-BC89D1-1D-EN
Variable Speed ComfortLink™™ II
Heat Pumps and Air Conditioners
4TWV0024A1000A
4TWV0036A1000A
4TWV0048A1000A
4TWV0060A1000A
4TTV0024A1000A
4TTV0036B1000A
4TTV0048A1000A
4TTV0060A1000A
4TTV0061A1000A
Scan to see help
videos on this
product
NNoottee:: “Graphics in this document are for representation
only. Actual model may differ in appearance.”
Installer’s Guide

Trane 4TWV0036A1000A Specifications

General

Brand	Trane
Model	4TWV0036A1000A
Category	Heat Pump
Language	English

Summary

Outdoor Safety Precautions

Electrical Hazards

Warns of severe injury/death from high voltage and leakage currents.

Refrigerant & Oil Safety

Addresses refrigerant pressure, oil hazards, and hot surfaces.

Grounding & Service Valve Safety

Emphasizes grounding and safe service valve operation.

Brazing Safety

Warns of damage/injury from improper brazing procedures.

Electrical Hazard: 400 Volts

Approved Unit Combinations

Unit Location Considerations

Coastal Installation Considerations

Guidance for installations near salt water.

Unit Preparation

Setting Up the Unit

Instructions for physically positioning the unit on its pad.

Refrigerant Line Considerations

Refrigerant Line Brazing

Refrigerant Line Leak Check

Refrigerant Line and Indoor Coil Evacuation

Charging: Weigh-In Method

Service Valves

Electrical – Low Voltage Wiring

Electrical – High Voltage Power

Live Electrical Component Safety

Warns of injury/death from live components.

High Leakage Current Safety

Warns of injury/death from leakage current.

Integrated Variable Speed Control Board LEDs

Start Up Procedure

System Charge Adjustment

Subcooling Charging Correction Charts

Charging the Unit: Gage Pressure

Charging the Unit: System Information

Communicating Display Assembly (CDA)

Defrost Control for Heat Pumps

CDA Navigation for Forced Defrost

How to navigate CDA for defrost tests.

Final Checkout Procedures