Trane 4YCC4036E1070A User Manual

SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
January 2024
1188--EEBB4400DD11--11EE--EENN
Single Packaged Gas/Electric
13.4 SEER2 Convertible, 2 - 5 Ton
4YCC4024E1060A
4YCC4030E1070A
4YCC4036E1070A
4YCC4036E1090A
4YCC4042E1060A
4YCC4042E1090A
4YCC4048E1070A
4YCC4048E1090A
4YCC4060E1090A
4YCC4060E1115A
NNoottee:: “Graphics in this document are for representation
only. Actual model may differ in appearance.”
Installation and Operations Manual

Trane 4YCC4036E1070A Specifications

General

Model	4YCC4036E1070A
Type	Air Handler
Refrigerant	R-410A
CFM	1200
Phase	1
Voltage	208/230V
Maximum External Static Pressure	0.8 in. w.c.
Filter Type	Standard

Summary

SAFETY SECTION

Introduction, Unit Inspection and Specification

Product Specifications

Detailed technical data, ratings, and dimensions for different unit models.

Charging in Cooling above 55°F OD Ambient

Procedure for charging the system with refrigerant in cooling mode.

Charging Below 55°F

Review Location and Recommendation Information

Horizontal Airflow Units

Clearances

Down Airflow Units

Unit Installation

Rooftop Installation-Curb Mounting

Lifting and Rigging

Guidelines and warnings for safely lifting and rigging the unit.

Rooftop Installation – Frame Mounting

Rooftop Installation – No Curb/Frame

Gas Piping Installation

Procedure for connecting the gas supply line to the unit.

Gas Pressure Set-up Precautions

Gas Supply Line Pressure

Input Check and Adjustment

Electrical Wiring

Electrical Connections

Electrical Power

Ensuring adequate and correct electrical power supply for the unit.

Disconnect Switch

Power Wiring

Instructions for running power supply lines and making connections.

Control Wiring (Class II)

Unit Startup

Pre-Start Quick Checklist

Checklist of essential items before starting the unit for operation.

Starting the Unit in Cooling Mode

Procedure for starting the unit for cooling operation via thermostat.

Starting the Unit in Heating Mode

Procedure for starting the unit for heating operation via thermostat.

Sequence of Operation

Detailed explanation of heating and cooling cycle operations.

Final Installation Checklist

Verification steps to confirm proper installation and operation.

Maintenance

Service Maintenance

Recommendations for annual service maintenance by qualified technicians.

Pressure Curves

Cooling

Graphs showing system pressure vs. outdoor temperature for cooling.

Troubleshooting Chart