Trane 4YCC4042A1090A User Manual

SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
June 2020
1188--EEBB3311DD11--11FF--EENN
Single Packaged Gas/Electric
14 SEER Convertible, 2 — 5 Ton
4YCC4024A1060A
4YCC4030A1070A
4YCC4036A1070A
4YCC4036A1090A
4YCC4042A1060A
4YCC4042A1090A
4YCC4048A1070A
4YCC4048A1090A
4YCC4060A1090A
4YCC4060A1115A
Installer’s Guide

Trane 4YCC4042A1090A Specifications

General

Model	4YCC4042A1090A
Airflow	Up to 1400 CFM
Refrigerant	R-410A
Energy Efficiency Ratio (EER)	Up to 12.5
Voltage	208/230V
Phase	1
Shipping Weight	180 lbs
Cooling Capacity	3.5 Tons

Summary

Introduction and Safety

Installer's Guide Title

Main title and model information for the manual.

Safety Section Overview

Essential safety warnings and precautions for equipment handling.

Step 2 - Unit Clearances

Determine Unit Clearances

Diagrams and tables detailing required space for unit placement.

Clearance Tables and Dimensions

Tables detailing unit dimensions and corner weights.

Step 3 - Location and Recommendations

Review Location Information

Guidelines for unit placement and environmental considerations.

Clearances and Site Preparation

Further details on unit clearances and preparation advice.

Step 4 - Unit Installation

Ground Level and Rooftop Installation

Procedures for installing the unit at ground level or on a roof.

Lifting and Rigging

Safe practices for handling and positioning the unit during installation.

Ductwork, Gas, and Electrical Connections

Procedures for connecting ducts, gas supply, and electrical power.

Step 5 - Unit Startup and Operation

Unit Startup Procedures

Instructions for initiating operation in cooling and heating modes.

Sequence of Operation

Explains the unit's operational cycles, safety features, and fan settings.

Service Maintenance

Guidelines for routine inspections and servicing of the unit.