To Next PageTo Next Page
Need help?Do you have a question about the Trane 4YCC4030A1070A and is the answer not in the manual?
General| Model | 4YCC4030A1070A |
|---|---|
| Type | Air Handler |
| Refrigerant | R-410A |
| Voltage | 208/230V |
| Phase | 1 |
| Width | 21 inches |
| Shipping Weight | 140 lbs |
| Cooling Capacity | 30000 BTU/H |
| Nominal Cooling Capacity | 30, 000 BTU/h |
| Heating Capacity | 34000 BTU/H |
| Maximum Overcurrent Protection | 20 Amps |
| Minimum Circuit Ampacity | 15 amps |
| Motor Type | ECM |
| Depth | 21 inches |
Highlights hazards including voltage, gases, chemicals, and general safety precautions.
Checks for unit damage, correct nameplate, and refrigerant charge.
Provides diagrams and tables for recommended service and combustible material clearances.
Guidelines for locating and placing units for optimal performance based on airflow direction.
Instructions for ground mounting, flue hood setup, and airflow direction conversion.
Covers lifting, rigging, curb, frame, and flat roof installation methods.
Guidelines for connecting ductwork, condensate drains, and gas supply lines.
Procedures for gas pressure checks, altitude adjustments, and air filter installation.
Instructions for connecting power supply, conduit, and grounding to the unit.
Details low-voltage wiring, thermostat setup, and anticipator settings.
Diagram illustrating field wiring connections for thermostat and accessories.
Comprehensive checklist and steps for starting the unit in cooling and heating modes.
Post-startup checks and owner instructions to ensure proper operation and safety.
Explains the step-by-step operation for heating and cooling cycles.
Details safety devices, sequences, and diagnostic indicators for troubleshooting.
Outlines routine service and maintenance tasks for cooling and heating seasons.
