Trane 4YCC4060E1090 User Manual

SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
February 2023
1188--EEBB4400DD11--11CC--EENN
Single Packaged Gas/Electric
13.4 SEER2 Convertible, 2 - 5 Ton
4YCC4024E1060
4YCC4030E1070
4YCC4036E1070
4YCC4036E1090
4YCC4042E1060
4YCC4042E1090
4YCC4048E1070
4YCC4048E1090
4YCC4060E1090
4YCC4060E1115
NNoottee:: “Graphics in this document are for representation
only. Actual model may differ in appearance.”
Installation and Operations Manual

Trane 4YCC4060E1090 Specifications

General

Model	4YCC4060E1090
Type	Air Handler
Category	Air Handlers
Refrigerant	R-410A
Voltage	208/230V
Phase	1
Compressor Type	Scroll
Airflow	2000 CFM
Cooling Capacity	60000 BTU
Heating Capacity	60, 000 BTU

Summary

Safety Section

Safety Warnings and Precautions

General safety warnings regarding hazardous gases, voltage, and operational hazards.

Introduction, Unit Inspection and Specification

Product Specifications

Determine Unit Clearances

Unit Installation

Lifting and Rigging

Safety precautions and procedures for lifting and rigging the unit.

Ductwork Installation

Gas Piping Installation

Gas Pressure Set-up Precautions

Important safety and setup guidelines for gas piping.

Gas Supply Line Pressure

Verify Manifold Pressure

Input Check and Adjustment

Electrical Wiring

Electrical Connections

Electrical Power

Disconnect Switch

Over Current Protection

Power Wiring

Control Wiring (Class II)

Unit Startup

Pre-Start Quick Checklist

A checklist before starting the unit.

Starting the Unit in Cooling Mode

Procedure to start the unit in cooling mode.

Starting the Unit in Heating Mode

Procedure to start the unit in heating mode.

Sequence of Operation

Explanation of how the system operates in heating and cooling.

Final Installation Checklist

Final checks after unit installation.

Maintenance

Service Maintenance

Recommended service checks for cooling and heating seasons.

Flue Hood and Combustion Blower Cleaning

Indoor Fan Motor (IDM) Speed Tap Setting

Refrigerant Circuit

Troubleshooting Chart