To Next PageTo Next Page
Need help?Do you have a question about the Trane 4YCC4024E1060A and is the answer not in the manual?
General| Model | 4YCC4024E1060A |
|---|---|
| Type | Air Handler |
| Heating Capacity | 24000 BTU/H |
| Refrigerant | R-410A |
| SEER | 16 |
| Voltage | 208/230V |
| Phase | 1 |
| Frequency | 60 Hz |
| Depth | 21 inches |
| Cooling Capacity | 24000 BTU/H |
| Motor Type | ECM |
Covers hazards related to gases, voltage, electrical shock, and chemical exposure.
Details warnings for grounding, refrigerant handling, and unit operation safety.
Overview of manual, unit, and initial inspection procedures.
Detailed technical data and performance parameters for the unit models.
Guidelines for system charging in cooling mode based on ambient conditions.
Specifies required clearances and physical dimensions for installation.
Recommendations for unit placement and airflow configuration for optimal performance.
Further guidance on clearances and specific installation considerations.
Procedures for installing the flue hood and setting up ground-level installations.
Covers curb mounting, frame mounting, and converting airflow direction.
Safety guidelines and procedures for lifting and rigging the unit during installation.
Instructions for connecting downflow ductwork to roof curbs and frames.
Guidelines for connecting horizontal ductwork to the unit, including flexible connections.
Precautions for gas supply, pressure testing, and manifold pressure verification.
Procedures for verifying and adjusting gas input and flow rates.
Guide for changing burner orifices based on installation altitude.
Information on choosing and installing the correct air filter for the unit.
Instructions for connecting power supply, using disconnect switches, and overcurrent protection.
Guidelines for low-voltage control wiring, thermostat connections, and heat anticipator settings.
Checklist and steps for starting the unit in cooling and heating modes.
Explains the operational logic for cooling, heating cycles, and safety sequences.
Final checks to ensure proper installation and operation before owner handover.
Recommended checks for unit operation and components during cooling and heating seasons.
Procedures for cleaning the flue hood and combustion blower assembly.
Instructions for adjusting indoor fan motor speed via wiring tap settings.
Graphical representation of cooling performance based on pressure and temperature.
Tables detailing indoor fan airflow and static pressure performance across models.
Guides for connecting motor leads to achieve specific speed options for different models.
Schematic illustrating the path of refrigerant flow through the unit's components.
Guide to identify and resolve system faults based on primary and secondary causes.
Key details for unit identification and contacting service personnel.
